The ClearPath-MCVC model is used mainly for velocity (speed) control replacing AC induction motors, synchronous motors, DC motors, and more expensive (and non-integrated) servo systems. But it also has a torque mode, as well as the ability to precisely move between two different user-defined positions, so it can replace pneumatic and hydraulic cylinders. In all cases, you get smooth, quiet, bi-directional, and precisely servo-regulated motion in a low-cost, integrated package.
| Motor Frame Size | IEC D100* – 180.09 mm sq. |
| Length | 286.00 mm |
| Input Voltage Range Input Voltage for 5-wire systems |
100-240 VAC (1- or 3-phase) 300-415 VAC (3-phase, 5-wire) |
| Peak Torque (@230 VAC 3-ph) | 32.9 N-m |
| Cont. (RMS) Torque (@230 VAC 3-ph) | 13.4 N-m |
| Max Speed (@230 VAC 3-ph) | 2760 RPM |
| Achievable Resolution | 0.090 degrees |
| Repeatability | 0.006 degrees |
| Shaft Diameter | 28.00 mm |
| Weight | 12.8 kg |
| Rotor Inertia | 19.2 kg-cm² |
| Logic Input Voltage Range | 4.0 to 28 VDC |
| Maximum Radial Load | 756.2 N |
| Maximum Thrust Load | 177.9 N in; 311.4 N out |
| Ambient Temperature2 | -40° to +70° C |
| Ambient Humidity | 0-95%; non-condensing |
| Environmental Rating3 | IP65; blower kit not IP-rated |
| Regulatory Certifications | UL Recognized for use up to 240 VAC; CE certified for use up to 415 VAC; RoHS |
| Country of Origin | USA |
| Warranty | 3 Years |
| Ramp to Selected Speed | By changing digital inputs (from your PLC, switches, etc.), ClearPath will smoothly ramp to one of four preset speeds. |
| Manual Speed Control | Fine control of speed from zero to max speed at the turn of a knob. Remembers your last set speed or resets to zero speed when the motor is enabled. |
| Spin on Power Up | Just turn on the power and smoothly ramp to your preset speed. For when all you need is reliability, constant speed from a brushless motor, and a bare minimum of wiring. It doesn’t get any easier than this. |
| Variable Speed | Connect a digital waveform (PWM or frequency) from your PLC or other device, and ClearPath will run at a speed proportional to the waveform. (This mode can also be used to make ClearPath a drop-in replacement for a brush motor.) |
| Variable Torque | Apply a variable torque (or force or tension) in proportion to a digital command (PWM or frequency) |
| Sensor Positioning | Trigger ClearPath to move in either direction and it will smoothly ramp up to a chosen speed and stop when it detects a sensor (or switch). |
| Absolute Positioning | Trigger ClearPath to move to one of two preset positions. Perfect for replacing air cylinders where more power and finesse is needed. |
| Peak Torque |
32.9 N-m
|
| Cont. (RMS) Torque |
13.4 N-m
|
| Max Speed |
2760 RPM
|
| Peak Power |
5,647 W
|
| Cont. (RMS) Power |
2,981 W
|
